Move out of range

[lightdream68]

Hello,

Unfortunately I can't find a solution to the problem mentioned. The printer works so far (leveling etc.) but when I try to print I get this error: Move out of range: 0.000 -0.000 388.236 [0.000]

My printer.cfg

....
[printer]
kinematics: delta
max_velocity: 500
max_accel: 2000
max_z_velocity: 200
minimum_z_position: -20
delta_radius: 120

[stepper_a]
step_pin: PE3
dir_pin: !PE2
enable_pin: !PE4
rotation_distance: 32
endstop_pin: PA15
microsteps: 16
homing_speed: 80
position_endstop: 370
arm_length: 280.0

[stepper_b]
step_pin: PE0
dir_pin: !PB9
enable_pin: !PE1
rotation_distance: 32
endstop_pin: PA12
microsteps: 16

[stepper_c]
step_pin: PB5
dir_pin: !PB4
enable_pin: !PB8
rotation_distance: 32
endstop_pin: PC4
microsteps: 16

[probe]
pin: !PA11
x_offset: 0
y_offset: 0
z_offset: 18.237
samples: 3
samples_result: average
sample_retract_dist: 5
speed: 20
#helps with consistency of probing.

[delta_calibrate]
radius: 120
horizontal_move_z: -25
speed: 100
#ensure accurate probing

.....

[bed_mesh]
speed: 80
horizontal_move_z: 25
mesh_radius: 120
mesh_origin: 0,0
round_probe_count: 15
algorithm: bicubic #was lagrange
fade_start: 1
fade_end: 10

.....

[tmc2209 stepper_a]
uart_pin: PA10
#These pins are commented so you have to check which pins are connected to which steppers.
run_current: .850
hold_current: .500
interpolate: True
stealthchop_threshold: 0

[tmc2209 stepper_b]
uart_pin: PA9
run_current: .850
hold_current: .500
interpolate: True
stealthchop_threshold: 0

[tmc2209 stepper_c]
uart_pin: PC7
run_current: .850
hold_current: .500
interpolate: True
stealthchop_threshold: 0

[tmc2209 extruder]
uart_pin: PA8
interpolate: True
run_current: .850
hold_current: .500
stealthchop_threshold: 0

......

[gcode_macro START_PRINT]
gcode:
SET_GCODE_OFFSET Z_ADJUST=18.236 MOVE=1 # sets the z-offset

[gcode_macro END_PRINT]
gcode:
SET_GCODE_OFFSET Z_ADJUST=0 # resets the z-offset (otherwise, )

.....

Can anyone give me a tip on how I can get this under control?

Thanks

[conlank]

Check your slicer settings, it's commanding a move that is higher in Z then your machine limits.

[lightdream68]

Thanks for your answer, but I don't fully understand it. The value "minimum_z_position:" is set to -20 and "position_endstop:" is set to 370. So the stepper can travel a total of 390mm in the Z direction. With a z_offset = 18,237 that should be enough. Or what am I not understanding? I also set the position_endstop to 390. But that didn't help!