Printer Safety by Adjusting Parameters? #9
-
|
Hello, I am very interested in flashing the firmware, but I am afraid of the fact that it increases some parameters that are not found in the standard firmware, such as increased feedrate and X and Y acceleration. Is this still safe for the printer? Will it not shorten the lifespan when using different parameters than those advertised by Anycubic? Best regards, |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 1 reply
-
|
Hi there, the increased feed rate and acceleration actually only increase the maximum feed rate and acceleration that is possible via software. It won't magically turn up everything, that would certainly mess up the prints. It's perfectly safe as long as you don't mess with settings you don't fully understand 😄 Cheers! |
Beta Was this translation helpful? Give feedback.
-
|
Hi, Thank you so much for your detailed explanation! I really appreciate you taking the time to clarify this for me. The custom firmware is truly impressive, and I thank you for making it! Thanks again, and best regards! Mortis |
Beta Was this translation helpful? Give feedback.
Hi there,
the increased feed rate and acceleration actually only increase the maximum feed rate and acceleration that is possible via software.
The actual feed rate and acceleration are controlled via your slicer (e.g. Cura or PrusaSlicer).
It won't magically turn up everything, that would certainly mess up the prints. It's perfectly safe as long as you don't mess with settings you don't fully understand 😄
Cheers!