prj.conf

#CONFIG_NCS_SAMPLES_DEFAULTS
CONFIG_ASSERT=y
CONFIG_ASSERT_NO_COND_INFO=y
CONFIG_ASSERT_NO_MSG_INFO=y
CONFIG_RESET_ON_FATAL_ERROR=y

CONFIG_NCS_APPLICATION_BOOT_BANNER_STRING="SlimeVR-Tracker-nRF-Receiver"
#CONFIG_NCS_BOOT_BANNER=n
CONFIG_BOOT_BANNER=n

CONFIG_ESB=y
CONFIG_NEWLIB_LIBC=y
CONFIG_CBPRINTF_FP_SUPPORT=y

CONFIG_USB_DEVICE_STACK=y
CONFIG_USB_DEVICE_HID=y
CONFIG_USB_DEVICE_VID=0x1209
CONFIG_USB_DEVICE_PID=0x7690
CONFIG_USB_HID_BOOT_PROTOCOL=y
CONFIG_USB_DEVICE_INITIALIZE_AT_BOOT=n
CONFIG_USB_CDC_ACM=y
CONFIG_UART_INTERRUPT_DRIVEN=y
#CONFIG_USB_WORKQUEUE_STACK_SIZE=512

CONFIG_SERIAL=y
CONFIG_CONSOLE=y
CONFIG_UART_CONSOLE=y
CONFIG_UART_LINE_CTRL=y

CONFIG_LOG=y
#CONFIG_PRINTK=y
CONFIG_USB_DRIVER_LOG_LEVEL_WRN=y
CONFIG_USB_DEVICE_LOG_LEVEL_WRN=y
CONFIG_USB_CDC_ACM_LOG_LEVEL_OFF=y
CONFIG_LOG_BUFFER_SIZE=16384
CONFIG_LOG_PROCESS_THREAD_SLEEP_MS=100
CONFIG_LOG_PROCESS_THREAD_STACK_SIZE=1024

CONFIG_LOG_BACKEND_UART=y
CONFIG_LOG_MODE_DEFERRED=y

CONFIG_CONSOLE_SUBSYS=y
CONFIG_CONSOLE_GETLINE=y

CONFIG_NVS_LOG_LEVEL_WRN=y
CONFIG_USB_HID_LOG_LEVEL_WRN=y

CONFIG_USB_DEVICE_SOF=y
CONFIG_USB_HID_REPORTS=256

#CONFIG_USB_HID_POLL_INTERVAL_MS=1
CONFIG_USB_HID_POLL_INTERVAL_MS=0
CONFIG_HID_INTERRUPT_EP_MPS=64
#CONFIG_ENABLE_HID_INT_OUT_EP=y

CONFIG_GPIO=y
CONFIG_PWM=y

CONFIG_NVS=y

CONFIG_FLASH=y
CONFIG_FLASH_PAGE_LAYOUT=y
CONFIG_FLASH_MAP=y

CONFIG_SETTINGS=y
CONFIG_SETTINGS_NVS=y
CONFIG_SETTINGS_RUNTIME=y

CONFIG_MPU_ALLOW_FLASH_WRITE=y

CONFIG_NVS_LOOKUP_CACHE=y

CONFIG_ESB_TX_FIFO_SIZE=1
CONFIG_NRFX_TIMER1=y

#speed up boot? (use internal rc oscillator)
#CONFIG_CLOCK_CONTROL_NRF_K32SRC_RC=y
#speed up boot? (synthesize lf clock)
CONFIG_CLOCK_CONTROL_NRF_K32SRC_SYNTH=y

# dont need it
CONFIG_CRYPTO=n

CONFIG_THREAD_NAME=y
#CONFIG_SYSTEM_WORKQUEUE_STACK_SIZE=256
#CONFIG_MAIN_STACK_SIZE=512

#CONFIG_HEAP_MEM_POOL_SIZE=2048
CONFIG_ISR_STACK_SIZE=1024