Power and reset buttons still don't quite fit

[danboid]

I know I've reported this as an issue before and you said you had fixed it but I have recently printed another two Uzebox v2.0 enclosures on a prusa mk4 printer using the 10mm detailed print setting and the buttons don't quite fit. They just about fit in the case but there isn't enough vertical space free for the buttons to be pushed and click properly.

The workarounds are either I use a grinder to remove the excess filament in the inside of the top case around where the buttons make contact with the upper shell or, what I'll most likely be doing this time as a quick fix, I can redesign and reprint the buttons to reduce the length of the buttons legs slightly.

[danboid]

Today I printed some buttons where I reduced the length of the shaft by 1.5 mm. They fit in my cases better as they click now but they're a little too short as they can get displaced from the socket a bit.

I reckon making the button shafts 1 mm shorter will be about right so I'll try that on Wednesday and report back.

[danboid]

It'd be best if you could send me some .3mf files of the buttons with 1 mm shorter shafts @uze6666 so I could print and test those.

I used blender for this first test. Blender doesn't natively support importing or exporting .3mf but there is a plugin for adding .3mf support. Importing the buttons seemed to work fine but I had problems with missing surfaces when I exported the buttons so I exported them as .stl files, which blender does have integrated support for, and that output files that cura was happy with.

If you don't have time before Wednesday I'll do it myself again but I will be sharing .stl files as a result, if they fit properly.