MIB STD2 Toolbox for v0472T

[gondeeri]

Hello,

Please I have version 0472T and I am not able install latest version 1.2.1 ..there is this notice Medium: Device doesn't support this(MainUnit: variant)

Could you pls help how to proceed?

Thanks

[lprot]

Would you mind to carefully read readme? Thank you!

[lprot]

you skipped the word CAREFULLY as there is mentioned that installation from SD card is possible ONLY for navi units with two SD slots...

[gondeeri]

But I have units with two SD Slots ... and I put SD to first slot where was SD with maps.... So please where should be a problem ?

[olli991]

You'll have virtual cockpit and / or beats audio system. Unit is not supported via SD method

[lprot]

then this is the reason:
NOTE: This SD installation method is NOT possible on Seat units with HW H50+ (firmwares 05xx) also known as variants 47213, 47214, 47215, 47216. Metainfo2.txt of the Toolbox does not contain these variant numbers. Metainfo2.txt cannot be edited because has digital signature at the end of the file. The ONLY KNOWN way to install Toolbox onto this kind of units is soldering USB SD card reader to eMMC.

Please do following:
Long press MENU, then go to "Testmode->Green Engineering Menu->debugging->additional debug destination. With the right knob, select SD card, press on the right knob and /log/log-001 will be written onto SD.

Attach the file here. Let's check what variant does your unit have.

[gondeeri]

You'll have virtual cockpit and / or beats audio system. Unit is not supported via SD method

yes I hvae virtual cockpit and seat sound system as well

[gondeeri]

then this is the reason: NOTE: This SD installation method is NOT possible on Seat units with HW H50+ (firmwares 05xx) also known as variants 47213, 47214, 47215, 47216. Metainfo2.txt of the Toolbox does not contain these variant numbers. Metainfo2.txt cannot be edited because has digital signature at the end of the file. The ONLY KNOWN way to install Toolbox onto this kind of units is soldering USB SD card reader to eMMC.

Please do following: Long press MENU, then go to "Testmode->Green Engineering Menu->debugging->additional debug destination. With the right knob, select SD card, press on the right knob and /log/log-001 will be written onto SD.

Attach the file here. Let's check what variant does your unit have.

When I press MENU for long time nothing will happen...still have basic servis menu ...like on the picture... so I am not able provide the file...

[lprot]

That means developer mode is not activated in adaptations of block 5F. You can activate it via Car Scanner/OBD11/VCDS/ODIS etc.