Tune default cura2 params

fluxclient/printer/__init__.py

@@ -280,7 +280,7 @@ def float_or_percent(key, value, percent_start=float('-inf'), percent_end=float(
 infill_sparse_thickness = 0.1
 gradual_infill_steps = 0
 gradual_infill_step_height = 5
-infill_before_walls = true
+infill_before_walls = false
 min_infill_area = 0
 material_flow_dependent_temperature = false
 default_material_print_temperature = 210
@@ -292,25 +292,25 @@ def float_or_percent(key, value, percent_start=float('-inf'), percent_end=float(
 material_extrusion_cool_down_speed = 0.7
 material_bed_temperature = 60
 material_bed_temperature_layer_0 = 60
-material_diameter = 2.85
+material_diameter = 1.75
 material_flow = 100
 retraction_enable = true
 retract_at_layer_change = false
-retraction_amount = 6.5
-retraction_retract_speed = 25
-retraction_prime_speed = 25
+retraction_amount = 8
+retraction_retract_speed = 80
+retraction_prime_speed = 80
 retraction_extra_prime_amount = 0
-retraction_min_travel = 1.5
+retraction_min_travel = 0.8
 retraction_count_max = 90
-retraction_extrusion_window = 4.5
+retraction_extrusion_window = 8
 material_standby_temperature = 150
 switch_extruder_retraction_amount = 20
 switch_extruder_retraction_speed = 20
 switch_extruder_prime_speed = 20
 speed_infill = 60
-speed_wall_0 = 30
-speed_wall_x = 60
-speed_topbottom = 30
+speed_wall_0 = 28
+speed_wall_x = 40
+speed_topbottom = 20
 speed_support_infill = 60
 speed_support_interface = 40
 speed_prime_tower = 60
@@ -405,7 +405,7 @@ def float_or_percent(key, value, percent_start=float('-inf'), percent_end=float(
 raft_airgap = 0.3
 layer_0_z_overlap = 0.22
 raft = 0
-raft_surface_layers = 2
+raft_surface_layers = 4
 raft_surface_thickness = 0.1
 raft_surface_line_width = 0.4
 raft_surface_line_spacing = 0.4